Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Geneva, FL
Regent Gate Repair is the gate company Geneva homeowners call when a driveway gate sags, an operator stops responding, or a whole system needs replacing. We specialize in gate installation, and because Geneva sits on sandy, root-heavy acreage lots rather than tidy subdivision grids, most of our installs here involve custom driveway entries and field gates that were never built to a standard spec. From the control board to the hinge, we handle it. Call (855) 927-1091 for a free estimate.
Why Geneva Homes Are Different
Geneva is a rural, heavily wooded corner of Seminole County where properties are measured in acres, not square feet of lawn. Gated private driveways and pasture entries are the norm here, not HOA amenity gates. That changes the work. A gate on a Geneva lot usually sits at the end of a gravel or dirt drive, hung on posts that were set by a previous owner or a handyman, and exposed to full Florida sun all day. Sandy soil is the defining factor. After a heavy afternoon thunderstorm, the ground around gate posts softens and shifts. Live-oak and palmetto roots push against footings from below. Posts lean, hinges bind, and operators that were perfectly aligned in November are dragging by July. On acreage properties, we tune every installation to sandy-soil post and footing conditions, not off-the-shelf urban hardware. That means deeper footings, root-aware post placement, and alignment checks that anticipate wet-season movement.
Styles & brands we work with





Our Main Geneva Services
Most calls we get from Geneva fall into two buckets: a gate that’s stopped working mechanically, or an automated system that’s dead, half-opening, or beeping a fault code nobody can read. Here’s how we handle both.
Gate Repair in Geneva
Mechanical gate repair in Geneva usually comes down to what the soil and the climate did to the structure. Hinges rust, posts lean, gates drag on the ground, and latches stop lining up. We work on homeowner-built and custom gates constantly here because that’s most of the housing stock. A welded farm gate on a pasture entry needs a different repair approach than a powder-coated driveway gate on a paved approach, and we know which one we’re looking at when we pull up. If you’ve got a gate that won’t close, drags, or has pulled away from its post, this is the service. Gate Repair in Geneva

Electric Gate Repair in Geneva
Electric gate repair in Geneva is about diagnosing the operator, the control board, the safety sensors, and the wiring between them. The same sandy soil that shifts posts also strains underground wire runs, and Florida’s summer lightning doesn’t do control boards any favors. We work on LiftMaster, Mighty Mule, Elite, and FAAC operators regularly, so when a Geneva homeowner calls with a gate that opens but won’t close, or a keypad that went dark, we usually know the likely culprit before we arrive. If you’re dealing with a dead operator or an interrupted safety loop, read more about how we approach it. Electric Gate Repair in Geneva

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Geneva
Gate installation in Geneva means building for sandy soil, long driveways, and gates that get used hard. Whether you’re putting in a new automatic driveway gate on a five-acre lot, replacing a sagging field gate with something that actually opens, or adding a sliding gate across a pasture entry, the footing and alignment work matters more here than almost anywhere else in Seminole County. We install, wire, and program the full system, and because we’re a gate-only company, we’re the same crew you’d call for the installation that also handles the repair side if something fails later. Gate Installation covers the full scope of what we build.
Automatic Gate Installation
Signs you need it
You want a gate that opens from the vehicle without leaving the cab, or you’re tired of a manual gate that’s too heavy to move easily.
What it costs in Geneva
Automatic gate installation in Geneva typically runs $1,500 to $5,000 depending on the operator brand, gate size, and power run distance.
How we do it
We set or re-foot the posts, hang the gate, mount and wire the operator, connect the safety edges and photoelectric sensors, then program remotes and keypads on site.
Driveway Gate Installation
Signs you need it
Your existing driveway gate is rusted beyond repair, or you’re building a new entry and want a gate that matches the property.
What it costs in Geneva
Driveway gate installation in Geneva typically runs $1,500 to $5,000 including the gate, posts, hardware, and an operator if automation is part of the job.
How we do it
We survey the driveway approach and soil, set posts below the root zone where possible, hang the gate with adjustable hinges, and install an operator if the job calls for one.
Sliding Gate Installation
Signs you need it
Your driveway slopes or curves too sharply for a swing gate, or you need a gate that doesn’t sweep across a pasture apron or parking area.
What it costs in Geneva
Sliding gate installation in Geneva typically runs $2,000 to $6,500 because the track, rollers, and support post run longer than a swing gate system.
How we do it
We pour a level track base above the sandy soil, set the support and end posts, mount the rolling gate, and install a slide operator with proper limit and safety-stop adjustment.
What Gate Installation Costs in Geneva
| Item | Typical range in Geneva |
|---|---|
| Single swing gate with operator | $1,500 – $3,500 |
| Double swing gate with operator | $2,500 – $5,000 |
| Sliding gate with track and operator | $2,000 – $6,500 |
Can you install a gate on a dirt or gravel driveway in Geneva?
Yes. Most Geneva properties have unpaved driveways, and we set and re-foot posts specifically for sandy soil and off-pavement approach angles. The footing matters more than the surface. Call (855) 927-1091 for an exact quote.
Do you handle the wiring and the automatic opener as part of installation?
We do. The operator, control board, wire run, safety edges, and keypad programming are all part of the installation job. We don’t leave you to find an electrician afterward. Call (855) 927-1091 and we’ll walk through your gate layout.
Brands We Service in Geneva
We work on Mighty Mule, Elite, LiftMaster, and FAAC operators across Geneva, from simple residential swing arms to commercial-grade slide operators. Because we’re a gate-only shop, we carry common boards, remotes, and edge sensors on the truck, which cuts down on second trips when a part fails. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Geneva, FL
| Service | Typical range in Geneva |
|---|---|
| Gate repair diagnostic | $75 – $150 |
| Hinge replacement | $150 – $400 |
| Post re-footing or straightening | $300 – $900 |
| Gate frame repair | $200 – $600 |
| Electric gate diagnostic | $75 – $150 |
| Control board replacement | $350 – $900 |
| Safety sensor replacement | $200 – $450 |
| Gate opener or arm replacement | $500 – $1,500 |
| Automatic gate installation | $1,500 – $5,000 |
| Driveway gate installation | $1,500 – $5,000 |
| Sliding gate installation | $2,000 – $6,500 |
In Geneva, the two things that push a quote up are re-footing settled posts and long power runs from the house to the gate, which is common on acreage lots. Every price is quoted and agreed before any work starts, so the number you approve is the number you pay.
Neighborhoods We Serve in Geneva
Geneva’s layout is defined by roads, not subdivisions. We work along Snow Hill Road, Old Geneva Road, and throughout the rural pockets off County Road 426, where most properties sit on unpaved drives and large lots. Response across the 32732 zip is typically same day for repair calls and within a few days for installation scheduling.
- Geneva city center and the rural lots off First Street
- Snow Hill Road corridor
- Old Geneva Road and surrounding acreage
- Properties along County Road 426 toward the St. Johns River
- Rural Geneva south of State Road 46
Service Area – Cities Near Geneva
We also serve the neighboring communities around Geneva, including Oviedo, FL, Chuluota, FL, Winter Springs, FL, and Sanford, FL. If your gate is on the Seminole County side of the line or just over it, call and we’ll tell you straight whether we can get a truck to you.
Serving Geneva, FL — Our Local Coverage Area
We’re based in the Geneva area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Geneva
Most repair calls in the 32732 zip get a same-day or next-day visit. The exact window depends on how many calls are already on the schedule, but a gate that won’t close or won’t open gets priority. Call (855) 927-1091 to check today’s availability.
Most Geneva properties are not in HOAs, so the decision is usually yours. If your lot does sit in a community with covenants, check the rules before you order a gate. We’ll build to whatever spec your situation requires.
We cover the full 32732 zip, from the town center to the rural lots along Snow Hill Road and down toward the river. If you’re inside Geneva or just outside the line, call and we’ll confirm before you book.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Geneva Customers Say
"Fixed the immediate problem. He was honest that the operator is near end of life and I should budget for a replacement, which I appreciate even if it wasn't what I wanted to hear."
— Anika Patel"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
— Tim Brooks"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
— Jeff Ackerman